Figure 4-11: Ip Settings Screen; Figure 4-12: Mode Settings Screen - Cisco Linksys WVC210 User Manual

Wireless-G PTZ Internet Camera with Audio
11. If you selected Automatic Configuration-DHCP, proceed to the next step.
If you selected Static IP Address, the IP Settings screen will appear. Enter an IP Address, Subnet Mask, and
Default Gateway appropriate for your network. You must specify an IP Address and Subnet Mask on this
screen. If you are unsure about the Default Gateway, it is better to leave this field blank. Then complete the
Primary DNS and/or Secondary DNS fields. You must enter at least one DNS address, which can be obtained
from your ISP. Click Next to continue.
12. The Mode Setting screen will appear next. Click the Infrastructure radio button if you want the Camera to
communicate using an access point or wireless router. Click the Ad-Hoc radio button if you want the Camera
to communicate without using an access point or wireless router. After making your selection, click Next.
Chapter 4: Setting up and Mounting the Wireless-G Internet Camera
Setup Wizard

Figure 4-11: IP Settings Screen

Figure 4-12: Mode Settings Screen

15