Event Notification Window - Cisco Video Surveillance 3000 Series Configuration Manual

Event Notification Window

From the Feature Setup menu, click Event.
Step 3
The Event Notification window appears. If you change any options in this window, you must click the
Save button to save the changes. If you do not click this button, changes are not retained when you exit
the window. The Save button appears at the bottom of the window. You may need to scroll down to it.
Table 4-7
Table 4-7
Option
Event Triggering Area
Triggered by
Actions
Interval
Event Scheduling Area
Scheduling Grid
Cisco Video Surveillance 3000 Series IP Camera Configuration Guide
4-18
describes the options in the Event Notification window.
Event Notification Window Options
Description
Check the desired check boxes to designate the events that trigger actions:
Input 1—Event is triggered when input port 1 on the IP camera changes
•
state from high to low.
Motion Detection—Event is triggered when the camera detects motion,
•
if motion detection is configured as described the
rows in
• App—Event is triggered by an activity that is defined by an app that is
running on the IP camera.
Check the desired check boxes to designate that actions that the IP camera
takes when the corresponding trigger occurs.
• Email—Sends information about the event in an e-mail message to the
designated recipient. You design the recipient and configure other
e-mail options in other fields in this window.
Output 1—Changes the state of the output 1 port on the IP camera as
•
defined in the Port window.
Syslog—Sends information about the event to a designated Syslog
•
server.
HTTP—Sends information about the event as an HTTP stream to a
•
remote system.
FTP—Uploads a snapshot or video clip of the event to an FTP server.
•
Choose the time interval (in minutes) from the drop-down list to wait after
an event occurs before detecting the next event.
Designate the times at which an event causes the IP camera to take the
designed actions. If an event occurs during a time that is not designated, the
IP camera does not take any action.
Each cell in this grid represents one hour on the corresponding day, starting
at 12:00 a.m. (0:00). To designate times, click the desired cells. Selected
cells appear shaded.
To select all times, click the Set All button.
To deselect all times, click the Clear All button.
To change the scheduling settings to the last saved configuration, click
Undo All.
Table 3-1 on page 3-1.
Chapter 4 Feature Setup
"Motion Detection"
OL-32285-01