Rtc Battery - Toshiba PORTEGE A600 Maintenance Manual

4 Replacement Procedures
4 Replacement Procedures

4.16 RTC battery

CAUTION: Risk of explosion if battery is replaced by an incorrect type.
Removing the RTC battery
To remove the RTC battery, follow the steps below and refer to Figure 4-21.
1. Disconnect the RTC battery harness from the connector CN9300 on the system
board.
2. Remove the RTC battery holder (INSULATOR RTC BATT) fixed to the cover
assembly with the double-sided tape.
CAUTION: A cushion is fixed to the bottom of the RTC battery holder with a double-
3. Open the RTC battery holder (INSULATOR RTC BATT) while peeling adhered
portion with the double-sided tape and remove the RTC battery.
RTC battery holder
4-40
Downloaded from LpManual.com Manuals
Dispose of used batteries according to the laws and ordinances of your local
authority.
sided tape and the cushion is fixed to the cover assembly with a double-sided
tape. When removing the RTC battery holder, be careful not to break the
cushion of the bottom of the RTC battery holder.
CN9300
Figure 4-21 Removing the RTC battery
[CONFIDENTIAL]
RTC battery
PORTÉGÉ A600 Maintenance Manual (960-710)
4.16 RTC battery
RTC battery harness