Hitachi C12RA Instruction Manual page 11

INSTALLING THE CASTER (FIG. C)
1. Insert two bolts through the caster marked "R" (11)
and Rear-Right leg into short bottom bracket (12).
Fasten with two fl at washers and two nuts.
2. Assemble the other end of the caster bracket to the
Rear-Right leg using two bolts, fl at washers and
nuts.
3. Assemble the caster marked "L" to the Rear-Left leg
in exactly the same way.
NOTE: The caster marked "R" is used for the Rear-
Right leg, the caster marked "L" is used for the Rear-
Left leg.
Fig. C
9
INSTALLING THE PUSH-STICK AND BLADE
WRENCH STORAGE (FIG. D)
1. Assemble the push-stick and blade wrench hook (1)
to the hole of the leg using the nut (2).
INSTALLING THE SWITCH ASSEMBLY (FIG. D)
1. Assemble the switch (3) to the hole on Front-Left leg
using four screws (4).
Fig. D
4
2
1
1 12
11
3
– 11 –
INSTALLING THE DUST HOSE CLIP (FIG. E)
1. Assemble the dust hose clip (1) to the Rear-Left leg
using the bolt (2) and nut (3).
INSTALLING THE CARRYING HANDLE (FIG. E)
1. Assemble the two carrying handles (4) to the front
legs using the four screws and nuts.
Fig. E
3
1
2
BOLTING THE TABLE SAW
Four addition mounting holes (10 mm) provided at the
bottom of legs can be mounted to the fl oor.
Please use the L shape steel, screws and the
appropriate plastic plug (nut) to fi x the machine on the
concrete fl oor.
CHANGING BLADES (FIG. F, G, H)
WARNING
To avoid injury from accidental starting, always turn
the switch off ("0") and remove the power plug from
the power source before changing the blades.
1. Raise the saw blade to its maximum height.
2. Insert a L-shape rod supplied or screwdriver into the
hole (1) of the shaft to keep the arbor from turning.
3. Lower the saw blade to its lowest position.
Fig. F
English
4
1