Yamaha YP400T Service Manual page 30

Tool No.
Flywheel puller
Flywheel puller
Flywheel puller attachment
90890-01362
Flywheel puller
attachment
90890-04089
This tool is used to remove the generator
YM-33282
rotor.
Fork seal driver weight Fork seal driver weight
90890-01367
Fork seal driver attachment (41 mm)
YM-A9409-7
Fork seal driver
These tools are used to install the oil
attachment
seal, dust seal, and the outer tube bush-
90890-01381
YM-A5142-2 ing of a front fork leg.
Oil seal guide
90890-01396
This tool is used for protecting the oil seal
lip when installing the secondary sliding
sheave.
Steering nut wrench
90890-01403
YU-A9472
This tool is used to loosen or tighten the
steering ring nuts.
Pivot shaft wrench
Pivot shaft wrench
Pivot shaft wrench adapter
90890-01471
YM-01471
Pivot shaft wrench
adapter
These tools are used to tighten the sub-
90890-01476
frame adjusting bolt.
Sheave holder
90890-01701
YS-01880-A
This tool is used to hold the generator
rotor and clutch housing.
Compression gauge
Compression gauge
Adapter (compression gauge)
90890-03081
YU-33223
Adapter (compres-
sion gauge)
These tools are used to measure engine
90890-04082
compression.
Pocket tester
90890-03112
YU-03112-C
This tool is used to check the electrical
system.
Tool name/Function
1 - 14
SPECIAL TOOLS
Illustration
GEN
INFO