Checking The Exhaust System; Checking The Coolant Level - Yamaha YP400T Service Manual

CHECKING THE EXHAUST SYSTEM/

CHECKING THE COOLANT LEVEL

1
5
5
2
5
a
EAS00099
CHECKING THE EXHAUST SYSTEM
3
The following procedure applies to all of the
exhaust pipes and gaskets.
1. Remove:
• footrest board (right)
2. Check:
• exhaust pipe 1
• muffler 2
• gasket
3. Check:
• tightening torque
4
4. Install:
• footrest board (right)
EAS00103
CHECKING THE COOLANT LEVEL
1. Stand the scooter on a level surface.
NOTE:
_
• Place the scooter on a suitable stand.
• Make sure the scooter is upright.
2. Remove:
• coolant reservoir cover
3. Check:
b
• coolant level
3 - 32
Refer to "SIDE COVER MOULDINGS AND
FOOTREST BOARDS".
Cracks/damage → Replace.
Exhaust gas leaks → Replace.
Exhaust pipe nut 3
20 Nm (2.0 m · kg, 14 ft · lb)
Muffler joint bolt 4
14 Nm (1.4 m · kg, 10 ft · lb)
Muffler mounting bolt 5
53 Nm (5.3 m · kg, 38 ft · lb)
Refer to "SIDE COVER MOULDINGS AND
FOOTREST BOARDS".
Refer to "SIDE COVER MOULDINGS AND
FOOTREST BOARDS".
The coolant level should be between the
minimum level mark a and maximum level
mark b.
Below the minimum level mark → Add the
recommended coolant to the proper level.
CHK
ADJ