Special Tools - Yamaha YP400T Service Manual

EAS00027

SPECIAL TOOLS

The following special tools are necessary for complete and accurate tune-up and assembly. Use
only the appropriate special tools as this will help prevent damage caused by the use of inappropri-
ate tools or improvised techniques. Special tools, part numbers or both may differ depending on the
country.
When placing an order, refer to the list provided below to avoid any mistakes.
NOTE:
• For U.S.A. and Canada, use part number starting with "YM-", "YU-", or "ACC-".
• For others, use part number starting with "90890-".
Tool No.
Rotor holding tool
90890-01235
YU-01235
This tool is used to hold the primary fixed
sheave and clutch shoe assembly.
Ring nut wrench
90890-01268
YU-01268
This tool is used to loosen or tighten the
steering ring nuts.
Piston pin puller set
90890-01304
YU-01304
This tool is used to remove the piston
pins.
Radiator cap tester Radiator cap tester
90890-01325
Radiator cap tester adapter
YU-24460-01
Radiator cap tester
adapter
These tools are used to check the cooling
90890-01352
YU-33984 system.
T-handle
Damper rod holder
T-handle
90890-01326
Damper rod holder
These tools are used to hold the damper
90890-01460
rod when removing or installing the
damper rod.
Locknut wrench
90890-01348
YM-01348
This tool is used to remove or install the
clutch shoe assembly nut.
Tool name/Function
1 - 13
SPECIAL TOOLS
Illustration
GEN
INFO