Toyoset RCA-2800 Operation And Maintenance Instructions page 8

7. Remove the screw on the stem holding the bracket and
remove the bracket, spring and wick height adjuster
knob.
8. Turn the stem clockwise until it stops and remove the
wick sleeve with wick.
9. Lift the wick sleeve with wick up and remove it from the
primary air tube.
10. Squeeze the wick to loosen the three pins and remove
the wick from the wick sleeve.
11. Install the wick to the wick sleeve according to the
allowed direction engraved on the wick sleeve.
12. Install the wick sleeve with wick to the primary air
tube. And then install the top of the stem into the
groove of the wick sleeve with wick from right side,
and turn the stem counterclockwise until it stops.
13. Install the wick height adjuster knob, spring and
bracket. The wick position should be adjusted at No.1.
Then tighten the screw which is holding the stem.
14. Put the wick adjuster back into position.
7