Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Toyoset RCA-2800
Summary of Contents for Toyoset RCA-2800
- Page 1 PORTABLE KEROSENE HEATER OPERATION AND MAINTENANCE INSTRUCTIONS RCA-2800 Model...
-
Page 2: Assembly And Operation
ASSEMBLY AND OPERATION INSPECTION AND ASSEMBLY NOTE: Please save the shipping carton packing materials for future storage of your heater. 1. REMOVE PACKING MATERIALS Open the grille by raising the lower right hand corner of grille and pulling straight out. Remove the styrofoam packing wedge from under the top plate of cabinet to release the heat chamber assembly. - Page 3 1. Open the fuel tank lid on the top of heater cabinet and lift out the removable fuel tank. Turn the removable tank upside down and remove the fuel tank cap. 2. Insert the straight tube of the manual siphon into the kerosene container.
- Page 4 CHECK BEFORE LIGHTING 1. LEVEL THE HEATER The heater should be operated on a firm, level floor. NOTE: If your heater is not level, change locations. Do not prop it with books or other objects. 2. ENGAGE THE AUTOMATIC EXTINGUISHER The automatic extinguisher is engaged automatically by turning the wick adjuster knob clockwise.
-
Page 5: Adjusting The Flame
NOTE: An improperly seated heat chamber can cause high flame, smoke, and potential damage to the heater itself. Do not leave the heater until you have determined that the flame is burning normally, will be described in the following section. ADJUSTING THE FLAME 1. -
Page 6: Extinguishing The Flame
Pull the wick adjuster knob out completely. (It can be removed completely from its shaft.) Wick height adjuster knob The wick height adjuster knob, with three small holes marked 1, Wick height 2, and 3, can be seen. The stem pin is engaged in one of the adjuster knob holes. - Page 7 ASSEMBLY AND OPERATION REPLACING THE WICK WARNING: Before disassembling your heater, allow it to cool completely. 1. To release the automatic extinguisher, push the manual shutoff button. 2. After the heat chamber has cooled completely, open the grille and remove the heat chamber. 3.
- Page 8 7. Remove the screw on the stem holding the bracket and remove the bracket, spring and wick height adjuster knob. 8. Turn the stem clockwise until it stops and remove the wick sleeve with wick. 9. Lift the wick sleeve with wick up and remove it from the primary air tube.
- Page 9 NOTE: The space between the wick adjuster and the primary air tube Space should be even all around. Top of Top of wick primary adjuster air tube NOTE: Make certain the top of the wick adjuster and the top of primary air tube are the same height.
- Page 10 REPLACING THE IGNITER COIL WARNING: Before replacing the igniter coil, allow the heater to cool completely. 1. FIRST CHECK THE BATTERIES When the igniter coil no longer glows sufficiently to light the wick, replace the batteries. If proper glow is not restored, the igniter coil may be defective.
-
Page 11: Specifications
SPECIFICATIONS Model RCA-2800 Heat rating 10,000 BTU/h (2,530 kcal/h) Fuel tank capacity 3.6R Burning time / tank* 17 Hours Size (W 453 mm Weight 7.6 kg Wick adjuster Wick life extender mechanism Igniter Automatic, powered by two (2) “D” size batteries * Depending on wick setting, condition and fuel quality. - Page 12 TOYOTOMI CO., LTD. 5-17, Momozono-cho Mizuho-ku, Nagoya, Japan Printed in Japan New 1/07 7478000903...