Table of Contents
Advertisement
■ Removing the speaker holder
There is a space of approximately 1mm (0.04 inch) be-
tween the center part of the front glass of the speaker
holder and the surface of the Display unit. Set your fi nger
on the space in the center part of the front glass, then lift
and remove it.
■ Removing the TOP packing
1. Pull the TOP packing to the left to remove the packing
that is fi t into the left groove of the chassis. q
2. Pull the TOP packing to the right to remove the packing
that is fi t into the right groove of the chassis. w
3. Pull the TOP packing to the center to remove the packing
that is fi t into the center groove of the chassis. e
4. Remove the TOP packing. r
Note:
Remove the packing slowly, as the packing of the selec-
tor part might overset when the TOP packing is removed.
If the packing is turned over, return it to the normal posi-
tion using a soft tipped item (e.g., your fi nger).
DISASSEMBLY FOR REPAIR
Speaker holder
Display unit
2. Precautions for Reassembly
■ Apply the bond to the inside of the selector
circle nut and volume circle nut
Apply the bond (W05-0019-00) or "THREE BOND 1401B"
at two points inside of the circle nut before tightening the
circle nut.
Circle nut
■ Mounting the chassis onto the case
1. Place the key top on the chassis. Then, fit the chassis
tightly into the groove of the key top. q
Note:
Confi rm that the entire groove of the key top fi ts to the
chassis tightly.
2. Mount the chassis onto the case. w
Note:
• After mounting the chassis onto the case, if the 16-
key part on the key top gets stuck inside the case as
shown in the fi gure, return it to the normal position us-
ing a soft tipped item (e.g., your fi nger). e
Prying it with a pointed metal tool such as forceps,
may damage the key top or packing.
• Confi rm that the TOP packing is not caught in the An-
tenna or Volume holes of the case.
NX-320
16-key part
Volume of TOP packing
Antenna of TOP packing
9
Hide quick links:
Advertisement
Table of Contents
