Fujitsu SPARC T5440 User Manual page 85

PCIE5 PCIE FJSV,e4ta-fjgi
/pci@500/pci@0/pci@c/pci@0/pci@9/pci@0/pci@1/pci@0/FJSV,e4ta@4,1
PCIE5 PCIE FJSV,e4ta-fjgi
/pci@500/pci@0/pci@c/pci@0/pci@9/pci@0/pci@1/pci@0,1/FJSV,e4ta@6
PCIE5 PCIE FJSV,e4ta-fjgi
/pci@500/pci@0/pci@c/pci@0/pci@9/pci@0/pci@1/pci@0,1/FJSV,e4ta@6,1
PCIE5 PCIE FJSV,e2ta-fjgi
/pci@500/pci@0/pci@c/pci@0/pci@9/pci@0/pci@9/pci@0/FJSV,e2ta@4
PCIE5 PCIE FJSV,e2ta-fjgi
/pci@500/pci@0/pci@c/pci@0/pci@9/pci@0/pci@9/pci@0/FJSV,e2ta@4,1
...
Fujitsu 4Gbps Fibre Channel Card Is Falsely
Recognized as F20 Card (CR 6947945)
This issue is resolved by updating the system firmware to 7.2.10 or later.
When you mount a Fujitsu 4Gbps Fibre Channel card and start the system, the
4Gbps Fibre Channel card is falsely recognized as a F20 card in the ILOM CLI
interface. Also, the slot number is falsely displayed. In addition, the false
recognition and the false display may occur also in the FRU Status of the prtdiag
-v command output.
Shown below is an event example in time of failure.
Configuration:
PCIE#0: Fibre Channel card
PCIE#1: void
PCIE#2: void
PCIE#3: void
PCIE#4: void
PCIE#5: void
The ILOM CLI interface output example:
/SYS/MB/RISER1/PCIE1/F20CARD
Properties:
Broadcom,BCM5704C
Broadcom,BCM5704C
Broadcom,BCM5704C
Broadcom,BCM5715C
Broadcom,BCM5715C
type = F20 Card
ipmi_name = RSR1/PCIE1/F20
fault_state = OK
clear_fault_action = (none)
Appendix A Fixed Issues 75