2.4 TYPES OF SPIN CYCLE
2.4.1
Anti-unbalancing during spinning
The check for balancing of the wash load is performed while the drum rotates at a speed of 85 rpm, before
the spin phase. If the wash load is unbalanced, the spin cycle is not carried out; after rotating the drum
several times at low speed in alternate directions, the spin cycle is restarted.
If the wash load is still unbalanced, this procedure is repeated until the correct balance is achieved.
If the wash load is still unbalanced after the maximum time (about 20 minutes), the timer passes to the
subsequent phase and the spin cycle is skipped.
2.4.2
Example of intervention of anti-unbalancing and pressure switch level during spin phases
(1) passe to the subsequent step or next stop
(2) passes to the subsequent phaase
2.4.3
Spin phases key
Time
Time
TO
maximum time (TimeOut)
SUV
Software Unbalance Value
UDV
Unbalance Detected Value
st
L>, L1>
1
Level pressure switch on "Full"
st
L<
1
Level pressure switch on "Empty"
PTO
maximum drain time (Pump TimeOut)
STO
maximum time for spin sequence (Sequence TimeOut)
2001.08 eb
17
599 34 85-05