Enter Your Latitude & Longitude - KVH Industries TracVision M5 Installation Manual

Control panel configuration
Hide thumbs Also See for TracVision M5:
Table of Contents

Advertisement

Enter Your Latitude & Longitude
14
Follow these steps to turn on the system and
enter your vessel's latitude and longitude.
NOTE: The antenna will use your position
information to speed up satellite acquisition. If the
antenna knows where you are, it knows where it
should start looking for the satellite. In addition, for a
linear system, the antenna will use your position
information to calculate the correct LNB skew angle.
a. Ensure the antenna has a clear, unobstructed
view of the sky.
b. Apply power to the satellite TV receiver(s),
TV(s), and switchplate (see Figure 33). Wait
two minutes for system startup.
c. Press the center MENU button on the MCP's
front panel to access the onscreen menu (see
Figure 34).
d. At "Install satellite?", press NEXT until the
display shows "Operations mode?" Then
press YES.
e. At "Get antenna status?", press NEXT until
the display shows "Control antenna?" Then
press YES.
f. At "Man control antenna?", press NEXT until
the display shows "Set Lat/Long?" Then
press YES.
g. At "Latitude", use the - and + buttons to set
each digit of the vessel's latitude. Press
ENTER to accept each digit.
h. At "Longitude", use the - and + buttons to set
each digit of the vessel's longitude. Press
ENTER to accept each digit.
i.
At "Latitude/Longitude", verify that the
display shows the correct latitude and
longitude.
j.
After 3 seconds, the display returns to the
"Set Lat/Long?" screen. Press RETURN until
you exit the menu.
16
Figure 33: Switchplate Power Switch
ON
OFF
Figure 34: Lat/Long Menus on MCP
Menu
Install satellite?
Yes
Next
Return
Until "Operations mode" shown
Operations mode?
Yes
Next
Return
Get antenna status?
Yes
Next
Return
Until "Control antenna" shown
Control antenna?
Yes
Next
Return
Man control antenna?
Yes
Next
Return
Until "Set Lat/Long" shown
Set Lat/Long?
Yes
Next
Return
Latitude:
-
Enter
Use +/- to set vessel latitude
Longitude:
-
Enter
Use +/- to set vessel longitude
Latitude:
Longitude:
##N
+
###E
+
##N
###E

Advertisement

Table of Contents
loading

Table of Contents