Select Satellites - KVH Industries TracVision M5 Installation Manual

Select Satellites

15
Follow these steps to set up the system for the
desired pair of satellites.
IMPORTANT!
To select a three-satellite (Trisat) group for a
linear system, see Appendix C on page 29. To
select a DIRECTV HDTV three-satellite
(Trisat) group, see Appendix A on page 23.
a. Press the center MENU button on the MCP's
front panel to access the onscreen menu (see
Figure 35).
b. At "Install Satellite?", press YES.
c. At "Trisat Mode?", press NO.
d. At "Install A <SAT NAME>", press NEXT
until the display shows the first (primary)
satellite you want to select. Then press YES.
(See Appendix D on page 30 for a list of
available satellites.)
NOTE: If you don't find the satellite you want,
you can set up a user-defined satellite (USER 1 or
USER 2). See Appendix E on page 31.
e. Repeat Step 15d to select the second satellite.
If you want to set up the antenna to track just
one satellite, select "None" instead.
f. Wait two minutes while the antenna restarts.
g. (Linear only) Set up the receiver(s) for the
same satellites, and in the same order, that
you set them up in the antenna:
Antenna Receiver
Sat. A Alternative 1 or A
Sat. B Alternative 2 or B
Figure 35: Satellite Selection Menus on MCP
Install satellite?
Yes
Yes
Install A <SAT NAME>
Yes
Install B <SAT NAME>
Yes
<SAT NAME2> installed
Restarting antenna
DiSEqC
DiSEqC 1
DiSEqC 2
Menu
Next Return
Trisat mode?
No Return
Next Cancel
Press NEXT until desired satellite shown
Next Cancel
Press NEXT until desired satellite shown
Installing sats
Please wait
<SAT NAME1> and
17