Slant/Fin Victory VSPH series User Manual page 9

VICTORY VSPH Models
VICTORY VSPH MODELS NON - DIRECT VENT, SIDEWALL VENTING
Figure 5. Non-direct vent, side wall venting.
Figure 6. Non-direct vent, side wall venting.
** Definition of Snow Line: Knowledge of local conditions will reveal the maximum height that repeated snowfalls accumulate to.
The height should be used as the SNOW LINE.
AL 29 4C IS A REGISTERED TRADEMARK OF ALLEGHENY LUDLUM CORP
*
All joints must be liquid and pressure tight. Use U/L listed single wall 3" dia.
AL29 4C S.S.*. venting materials (See page 5).
3" DIA
S.S. FLUE
PIPE (SEE
PAGE 5)
3" DIA
S.S. FLUE
PIPE (SEE
PAGE 5)
A WALL THIMBLE MUST BE USED
ON COMBUSTIBLE WALLS. S/F P/N
442321 ADJUSTIBLE 127 MM TO 203
MM (5 IN. TO 8 IN.) MAY BE USED.
ABOVE THIMBLE MUST BE USED
WITH HEAT-FAB 18" SLIP JOINT
CONNECTOR.
A U/L LISTED WALL THIMBLE MUST
BE USED ON COMBUSTIBLE WALLS.
S/F P/N 442321 ADJUSTIBLE 127 MM
TO 203 MM (5 IN. TO 8 IN.) MAY BE
USED. ABOVE THIMBLE MUST BE
USED WITH HEAT-FAB 18" SLIP
JOINT CONNECTOR.
.
9