Sharp LC-32LE705E/S Service Manual page 13

5. Removing of Bezel Ass'y, Panel Chassis Ass'y, Lens Sheet, Diffusion Plate, Back Light Chassis and LCD
Control Unit (46 inch models).
NOTE: A clean booth is required for repair of the component units and/ or parts (LCD Panel HIRAKI, LED PWB etc.) inside the LCD panel module
unit.
1. Remove the 10 lock screws
2. Remove the 4 Clips and detach the 46" LCD Panel HIRAKI Unit and Panel Chassis Ass'y
3. Detach the DBEF Sheet
4. Remove the 23 Push Rivets
5. Detach the 2 Connection Cords
6. Remove the 48 Push Rivets
7. Detach the Bush Cap Unit
8. Remove the 8 Terminators
and 4 LED6-PWB2 Units
9. Detach the 4 LED5-PWB1 Units
10.Detach the Back Light Chassis
11.Detach the 2 Ferrite Cores
12.Remove the 6 lock screws
Panel Chassis Ass'y 5
46" LCD Panel HIRAKI Unit
3 Bezel Ass'y
,16 lock screws and detach the Bezel Ass'y
and 2 Lens Sheet and Diffusion Plate
and 11 Support Pins and detach the Reflector Sheet
.
.
and connecting cords from the 8 connectors
and 16 connections and detach the 4 LED8-PWB1 Units
.
and 4 LED5-PWB2 Units
.
.
and detach the LCD Control Unit
Diffusion Plate 8
Lens Sheet 7
DBEF Sheet 6
4
22
2
1
10 Support Pin
11
9 Push Rivet
LC-32/40/46LE705E/S, LU705E/S, LX705E, LC-52LE705E/S
.
.
of the LED5-PWB1/2 Unit.
.
.
Clip
15
17
20
21
17
23
13
Reflector Sheet
1 – 5
.
.
, 4 LED8-PWB2 Units , 4 LED6-PWB1 Units
14 Bush Cap Unit
24 Back Light Chassis
LCD Control Unit 27
12 Connecting Cord
18
19
16
26
25 Ferrite Core