Sharp LC-32LE705E/S Service Manual page 11

3. Removing of Bezel Ass'y, Panel Chassis Ass'y, Lens Sheet, Diffusion Plate, Back Light Chassis and LCD
Control Unit (40 inch models).
NOTE: A clean booth is required for repair of the component units and/ or parts (LCD Panel HIRAKI, LED PWB etc.) inside the LCD panel module
unit.
1. Remove the 14 lock screws
2. Remove the 4 Clips and detach the 40" LCD Panel HIRAKI Unit and Panel Chassis Ass'y
3. Detach the DBEF Sheet
4. Remove the 20 Push Rivets
5. Detach the 2 Connection Cords
6. Remove the 42 Push Rivets
7. Detach the Bush Cap Unit
8. Remove the 7 Terminators
9. Detach the 4 LED5-PWB1 Units
10.Detach the Back Light Chassis Ass'y
11.Detach the 2 Ferrite Cores
12.Remove the 6 lock screws
3 Bezel Ass'y
,12 lock screws and detach the Bezel Ass'y
and 2 Lens Sheet and Diffusion Plate
and 8 Support Pins and detach the Reflector Sheet
.
.
and connecting cords from the 7 Connectors
and 14 connections and detach the 8 LED6-PWB1 Units
and 3 LED5-PWB2 Units
.
.
and detach the LCD Control Unit
Lens Sheet 7
DBEF Sheet 6
Panel Chassis Ass'y 5
40" LCD Panel HIRAKI Unit
1
2
10 Support Pin
9 Push Rivet
LC-32/40/46LE705E/S, LU705E/S, LX705E, LC-52LE705E/S
.
.
of the LED5-PWB1/2 Unit.
.
.
Diffusion Plate 8
4 Clip
15
21
17
18
19
17
20
13
11 Reflector Sheet
1 – 3
.
.
and 6 LED6-PWB2 Units
14 Bush Cap Unit
22 Back Light Chassis Ass'y
24
LCD Control Unit 25
23 Ferrite Core
12 Connecting Cord
19
18
16
.