KTM 950 SUPER ENDURO R 950 Owner's Manual page 67

»
MAINTENANCE WORK ON CHASSIS AND ENGINE
66
Remove the drain plug [1] from the oil tank and allow the oil to drain into a vessel. Remove
the screws [2] and tilt the connector [3] to the side.
2
3
1
2
Carefully pull the oil screen [4] out of the oil tank.
Thoroughly clean the drain plugs, the cover and both oil screens. Clean all rubber seal rings
4
and check for damage. Replace if necessary.
Mount the oil drain plug on the engine with a new seal ring and tighten to 20 Nm.
Slide the oil screen [5] into the guides in the oil pump housing with the TOP mark facing
up. Make sure the form ring is in place and mount the cap [6]. Tighten the screws to
6
10 Nm.
5