Kilometers Or Miles - KTM 125 SX Owner's Manual

10
Display
X
SPEED / ODO
X X
SPEED / MAX
X X
SPEED / LAP
X LAP / LAP
X X SPEED / CLK
X
SPEED / H
X X
SPEED / TRP1
X X
SPEED / AVS1
X X
SPEED / STP1
X X
SPEED / TRP2
X X
SPEED / AVS2
X X SPEED / STP2
OVERVIEW OF TRIPMASTER FUNCTIONS
+
Press
no function
no function
starts / stops LAP
stops LAP, stores LAP
figure LAP remains figure, resets LAP to 0
next figure
no function
no function
no function
no function
no function
increases TRP2 figure
decreases TRP2 figure
no function
starts / stops STP2

Kilometers or miles

The unit (kilometers or miles) can also be changed. The ODO figure will be
retained and converted accordingly. The TRP1, AVS1, STP1, TRP2 and
AVS2 figures will be cleared.
To select the unit, select the SPEED/H mode and hold the MODE button for
3 seconds to access the SETUP menu. Press the MODE button 10 times
until the KMH/MPH function blinks. Press the + button to move to the
options. Press the + button for KMH or the – button for MPH. If no button
is pressed for 20 seconds, the setting will be stored automatically and the
display will return to the SPEED/H mode.
The setting can be stored immediately by holding the MODE button for a
few seconds until the display returns to the SPEED/H mode.
+ to access the menu
BUTTON
to activate the KMH setting
– to activate the MPH setting
BUTTON
press the MODE to change to the next mode
BUTTON
press and hold the MODE
BUTTON
to the SETUP menu
NOTE:
If you retrofit this Tripmaster on another motorcycle, the power can also be
supplied by the 12 V vehicle electric system. You will need an additional
cable harness, spare part no. 583.14.069.210, which you can order from
your KTM dealer.
–
Press Press MODE
no function next display mode
no function next display mode
next display mode
no function next display mode
no function next display mode
no function next display mode
no function next display mode
no function next display mode
no function next display mode
next display mode
no function next display mode
no function next display mode
3 to store the setting and return
SECONDS
Hold MODE for 3 sec
no function
resets MAX to 0
clears all LAP figures
next display mode
set clock menu
display setup menu
resets TRP1, STP1 and
AVS1 to 0
resets TRP1, STP1 and
AVS1 to 0
resets TRP1, STP1 and
AVS1 to 0
resets TRP2 to 0
next display mode
sets STP2 to 0