Quick Setup Guide - Sharp UX-B20 Service Manual

UX-B20U/UX-B20C/B25C

[5] Quick setup guide

IMPORTANT!!
Should you require any
assistance setting up or
operating your product,
please
DO NOT RETURN YOUR
PRODUCT TO THE
STORE.
After referring to the setup guide
and operation manual, if you still
require assistance please
consult our web page at
www.sharpusa.com. From our
web page you will be able to
directly e-mail our customer
support team.
If you would like personal
assistance, please call our
Customer Assistance Center at
1-877-794-8675.
4
Load paper.
1. Fan the paper. 2. Gently insert paper into the paper tray,
print side up ..
The stack should
not be higher
than this line
Do not force
paper down into
the feed slot
Note: If you are loading legal paper, see
of the operation manual to change the
paper size setting to LEGAL.
7
Install the Print Cartridge.
2. Open the
1. Make sure the
operation panel.
handset is on its
cradle and then
INK
press .
The cartridge
holder moves to
the cartridge
replacement
position.
6. Insert the new print cartridge
into the cartridge holder.
10.a. Press to select NEW.
ALIGN CARTRIDGE
ST AR T/
b. Press MEMOR Y
1=PRINT,2=SET
c. Press to print an alignment page.
1
2. Open the print
1. Open the
compartment cover.
operation panel.
2
Connect the handset.
5
4. Remove only the tape from the
3. Open the print
new cartridge.
compartment cover.
IMPORTANT: Make sure you
remove all of the tape.
7. Place your index finger on the tab and close
the cartridge holder cover with your thumb.
11.In the alignment page that the machine
prints, locate the line that comes closest
to forming a completely straight line.
Enter the number of that line.
Example:
(If you make a mistake, press
then repeat the entry.)
3. Remove the
packing tape.
3
1. Attach the paper tray.
Connect the phone line cord to the
TEL. LINE jack and a wall jack.
5. Make sure the cartridge holder has moved slightly away
from the right side of the compartment, and then pull the
green lever and open the cartridge holder cover.
Do not pull on the cable or touch the gold contact area.
Caution! Do not touch
Cable
the gold contact area.
8. Close the print compartment cover
and then the operation panel.
and
Note: To enter your name and fax number and set the date and time so that they
appear at the top of each fax you send, see page Chapter 1 of your operation manual.
1 – 10
4. Close the print 5. Close the
compartment cover. operation panel.
2. Attach the paper tray
extension.
Insert horizontally
and rotate up
Click!
If the tabs do not go into the
holes, turn the extension over.
6
Plug the power cord into a
120-V grounded outlet.
Gold contact area
INK
9. Press to make the cartridge
holder return to its home position.
Display:
CHANGE CARTRIDGE
1=NEW, 2=OLD
ST AR T/
12. Press MEMOR Y .