Table of Contents
Advertisement
Video: To select the video system.
Default Set: To return the menu items other than the video
system to their default settings, select Yes.
Phase: To set the H phase and SC phase.
Output: To select the signal type of outputs from SDI/ASI
1, 2, and 3 connectors.
Freeze Mode: To define the picture when the transmission
is interrupted:
OFF: Not to freeze the picture upon momentary
interruption.
ON: To freeze the picture upon momentary
interruption.
Note
With "Freeze Mode" set to OFF, the picture may be
distorted when momentary interruption of the stream
from the transmitter (camera adaptor) occurs.
WF SEQ: To select the signal for waveform monitor.
CCU No: To set the description of the connected camera
control unit in a system using multiple receiving units.
Specify a two-character alphanumeric description.
Low Batt: To set the battery voltage at which an alarm
message to be displayed.
Bars: To select the signal of the built-in signal generator.
The selectable signals differ between NTSC and PAL.
NTSC
CB1
75% (7 stripes)
CB2
75% (8 stripes)
SDI EDH : To set the EDH flag in SDI signals.
Status menu
To check the statuses. No settings can be made with this
menu.
Item
Submenu
Stream
Int-1
Int-2
Ext-1
Ext-2
Soft
—
PLD Version
AT
RX
DEC
VA
Wireless ID
—
Sys Timer
—
EL Timer
—
Stream: The statuses of input signals are displayed.
Int-1: Existence of the signal from the IF-1 INPUT
connector. If an appropriate load device is not
PAL
EBU 100%
EBU 95%
Values (default)
Exist, None, Open, Short
Exist, None, Open, Short
Exist, None
Exist, None
x.xx
x.xx
x.xx
x.xx
x.xx
n
n H
n H
connected, "Open" is displayed. If the connection is
short-circuited, "Short" is displayed.
Int-2: Existence of the signal from the IF-2 INPUT
connector. If an appropriate load device is not
connected, "Open" is displayed. If the connection is
short-circuited, "Short" is displayed.
Ext-1: Existence of the signal from the STREAM-1
INPUT connector
Ext-2: Existence of the signal from the STREAM-2
INPUT connector
Soft: The version of the AT software is displayed.
PLD Version: The version of the PLD software of each
internal board is displayed.
Wireless ID: The model name and device ID of the
transmitter are displayed.
Sys Timer: The accumulated operating time of the system
is displayed.
EL Timer: The accumulated operating time of the EL
display is displayed.
Setting the Menu Items
1
Press the MENU dial.
The unit enters Menu Item Selection mode, and the
Main Menu is displayed on the display.
*Menu*
c Wireless
Audio
Setup
Status
2
Rotate the MENU dial to move the cursor (c) to the
item to be set.
Downward rotation moves the cursor downwards, and
upward rotation moves it upward.
3
Press the MENU dial.
The items of the selected main menu item is
displayed.
Example: "Wireless" selected
*Wireless*
c Freq:
CH1
Freq:
2406MHz
Stream:
Auto
Descramble
The item with >> has submenus. Select the lower
layer for setting.
>>
>>
>>
>>
>>
19
Menu Settings
Advertisement
Table of Contents
