Table of Contents
Advertisement
Hard drive
NOTE:
isolators, or screws. These components are included in the Hard Drive Hardware Kit, spare part
number 664913-001.
Description
500-GB, 5400-rpm
320-GB, 5400-rpm
250-GB, 5400-rpm
Before removing the hard drive, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the service cover (see
Remove the hard drive:
1.
Disconnect the hard drive connector cable (1) from the system board.
2.
Remove the Phillips PM 2.0×5.0 screw (2) that secures the hard drive to the computer.
3.
Use the pull tab (3) to lift the left side of the hard drive until it rests at an angle.
Downloaded from LpManual.com Manuals
The hard drive spare part kit does not include the hard drive bracket, connector cable, rubber
Battery on page
50).
WLAN module on page
52).
Spare part number
634932-001
645193-001
645191-001
Component replacement procedures
59
Advertisement
Table of Contents
