Configure The Settings Relating To The Flange-Back [Back-Focus] - Panasonic WV-NP1000 Operating Instructions Manual

Configure the settings relating to the flange-back [BACK-
FOCUS]
Select the method of the flange-back length adjustment and adjust the flange-back length minutely. The settings can
be configured on the "BACK-FOCUS SETUP" page. Before adjusting the flange-back length, adjust the lens first.
( Operating instructions (book))
Refer to the operating instructions (book) for descriptions of how to display the "BACK-FOCUS SETUP" page.
<About the flange-back length adjustment>
The flange-back length is the distance between flange surface and the focal point.
Important:
• The "ABF" (auto back focus) function is for adjustment of the flange-back length at the installation, and for focus
compensation when shifting between colour and B/W after the installation. This function is not supposed to be
used for sequential action such as the auto focus function.
• It is necessary to adjust the flange-back length again when images become out-of-focus caused by aging of the
lens and the environment change, etc.
Note:
The flange-back length adjustment can be performed using the operation buttons on the camera ( Operating
instructions (book)).
<BACK-FOCUS SETUP page>
**BACK-FOCUS SETUP**
ABF PUSH SW
MANUAL-ADJ
C/L B/W AUTO
SETUP-SW LOCK OFF
NEAR
......... | .........
INDICATOR XXXX
RET TOP END
[ABF]
When the [SET] button is pressed after moving the cur-
sor onto "PUSH SW", the auto-back focus function will
be activated and adjust automatically the flange-back
length to a subject located at the centre of the screen.
[MANUAL-ADJ]
To adjust the flange-back length finely, press the [SET]
button after moving the cursor onto "MANUAL-ADJ".
The flange-back length can be adjusted manually using
the [Left] and [Right] buttons.
Notes:
• The flange-back length position will set to the default
position for the CS-mount by pressing both the [Left]
and [Right] buttons for 2 seconds or more.
• A value displayed for "INDICATOR" is an indication
for the flange-back length adjustment. When the
value becomes larger, the displayed image will be
sharper.
52
Notes:
• "ABF" is available only when "OFF", "X2 AUTO" or "X2 FIX" is selected for
"SENS UP".
• "AUTO" of "C/L ←→ B/W" is available only when "OFF", "X2 AUTO" or "X2 FIX"
FAR is selected for "SENS UP".
[C/L ←→ B/W]
Select a method of the flange-back length adjustment
from the following.
AUTO: Adjusts the flange-back length automatically to
correct out-of-focus which may be caused when
switching between the colour image display and the
BW image display.
PRESET: When switching between the colour mode and
the B/W mode, the flange-back length position will
move to the preset position of each mode. The latest
adjusted flange-back length positions for each mode
will be memorized automatically as the preset posi-
tion.
FIX: The position will be fixed after adjusting the flange-
back length manually or using the auto back focus
function (ABF).
Default: AUTO