Sony HVR-DR60 Service Manual page 68

(6) The "Input Drive Data" dialogue appears.
Click "OK".
(7) The HDD check starts.
The "Worker thread start" message appears.
It takes approx. 10 minutes to check the HDD.
(8) After the HDD check finishes normally, the "Worker thread is
done" message appears in the access log list.
×
Click "
" to finish.
The dialogue below appears to confirm "finish". Click "Yes".
HVR-DR60
Fig. 6-4-7
Fig. 6-4-8
Fig. 6-4-9
(9) • Confirm that the time lag from "Write-Read Check" to "Read
Cheak" is less than "3 minutes and 30second".
• Confirm that the time lag from "Read Cheak" to "Worker
thread is done."is less than "5 minutes and 30second".
(10) Terminate by clicking "
The dialogue below appears to confirm the termination. Click
"Yes".
Then, the check software is quit.
In case of abnormality
In case of abnormal check result is obtained, the message below
appears.
[Write NG, Start Block = xxxx, End Block = xxxx, Time = 'xx'
msec]
3. Confirm that no error exists.
4. Format the HDD.
Perform steps (1) to (10).
6-9
Fig. 6-4-10
×
".
Fig. 6-4-11
Fig. 6-4-12