Installing The Battery Connector; Removing The System Board - Dell Latitude 14 Rugged Owner's Manual

Installing the Battery Connector

1. Place the battery connector on the system board..
2. Tighten the screws that secure the battery connector to the computer.
3. Connect the battery connector cable.
4. Install:
a. I/O Board
b. Bottom Cover
c. Optical Drive
d. Hard Drive
e. Battery
5. Follow the procedures in

Removing the System Board

1. Follow the procedures in
2. Remove:
a. Battery
b. Hard Drive
c. Optical Drive
d. Bottom Cover
e. GPS Holder
f. WLAN Card
g. WWAN Card
h.
3. Perform the following steps as shown in the illustration:
a. Lift the locking tab [1].
b. Disconnect the mother board connector cable [2].
After Working Inside Your computer
Before Working Inside Your Computer
33