e. Remove the screws that secure the driving board to the computer [5]
f. Lift the driving board from the computer [6].
Installing the Driving Board
1.
Place the driving board on the computer.
2.
Tighten the screws that secure the driving board on the computer.
3.
Connect the I/O board cable.
4.
Affix the adhesive tape.
5.
Connect the display assembly cable
6.
Affix the tape.
7.
Install:
a.
Bottom Cover
b.
Hard Drive
c.
Optical Drive
d.
Battery
8.
Follow the procedures in
Removing the Battery Connector
1.
Follow the procedures in
2.
Remove:
a.
Battery
b.
Hard Drive
c.
Optical Drive
d.
Bottom Cover
e.
I/O Board
f.
g.
3.
Perform the following steps as shown in the illustration:
a. Disconnect the battery connector cable [1].
b. Remove the screws that secure that battery connector [2].
c. Lift the battery connector [3].
32
After Working Inside Your computer
Before Working Inside Your Computer