Specifications And Options - Korg CX-3 Owner's Manual

5. Specifications and options

Tone generator section
Tone generator: Tone wheel organ modeling tone
generator
Polyphony: Full keyboard polyphony
Modes
Normal mode, EX mode, Normal Edit mode, EX Edit
mode, Global mode
Effect section
Vibrato/chorus, rotary speaker, overdrive, reverb
Number of programs
Normal mode: 64 (A-1–H-8)
EX mode: 64 (A-1–H-8)
Keyboard
61 note
Controllers
DRAWBAR SELECT section:
[DRAWBAR 1] key, [DRAWBAR 2] key, [PRESET
DRAWBAR] key (these are for the Upper tone generator)
[DRAWBAR 1] key, [DRAWBAR 2] key, [PRESET
DRAWBAR] key (these are for the Lower tone generator)
DRAWBAR section: Drawbar 1, Drawbar 2
PERCUSSION section: [ON] key, [SOFT] key, [FAST]
key, [3rd] key
ROTARY section: [ON] key, [STOP] key, [FAST] key
VIBRATO CHORUS section: [UPPER] key, [LOWER]
key, [VIBRATO/CHORUS] knob
AMP section: [MASTER LEVEL] knob, [TREBLE]
knob, [BASS] knob, [REVERB OFFSET] knob
Other: [EXPRESSION/OVERDRIVE] knob, [DIS-
PLAY] key, [EX MODE] key, [EDIT] key, [GLOBAL]
key, [WRITE/ENTER] key, [EXIT] key, PROGRAM
[1]–[8] keys, [ ][®] keys, [+]/[–] keys, [SPLIT] key
Outputs
OUTPUT L, R jacks:
Maximum output level ..... +17.5 [dBu]
Load impedance ..... 10 [k-ohm] or more
PHONES jack:
Maximum output level ..... 50 mw @ 32 ohms /
channel
Control inputs
EXPRESSION PEDAL jack
ASSIGNABLE PEDAL/SW 1, 2 jacks
Other
MIDI IN connector, MIDI OUT connector, MIDI
THRU controller, AC power supply connector, Power
switch
Dimensions (W x D x H)
1,082 x 403 x 148 (mm)
Weight
17 kg
Power consumption
14 W
Included items
Power cable, Expression pedal
Options
XVP-10 EXP/VOL pedal, EXP-2 Foot Controller, PS-1
Pedal Switch, MIDI cable
*Appearance and specifications of this product may change
without notice. (As of September, 2000.)
Operation of included Expression pedal
Fortissimo function
This allows you to selectively emphasise parts of your
performance.
As shown in the diagram, the pedal angle is 30 when
fully raised. The pedal will rest at any point you take
your foot off from fully raised to standard position.
If you depress the pedal further from standard
position, it will return to standard position when you
take your foot off.
Also, by adjusting the screw on the bottom, you may
adjust the spring return range from 0 –10 .
Selectable pedal angle
As shown below, you may change the pedal angle to
fit your plying position.
To select pedal angle
1. Loosen hook screw with a screwdriver.
2. Move the pedal body to the position in the illustration.
3. Retighten the hook screw.
Standing performance
hook screw
hook screw
Cable storage
Store the cable as shown.
Appendices
Range of free
20
movement
30
Standard position
0–10
Spring return range
Seated performance
33