Cleaning And Maintenance - Black & Decker Hand-held vacuum cleaner Manual

Features (fig. A)
1. On/off switch
2. Release button
3. Dust bowl
4. Hanging loop
Fig. A
5. Crevice tool (V2401/V2405/V3605/
V4890C/V4890CN/V4899/V6090C)
6. Brush tool (V2401/V2405/V3605/
V4890C/V4890CN/V4899/V6090C)
Assembly
V2401/V2405/V3605/V4890C/
V4890CN/V4899/V6090C -
Fitting the accessories (fig. A & B)
These models are supplied with the
following accessories:
a crevice tool (5) for confined spaces

a brush tool (6) for furniture and stairs

To fit an accessory, proceed as follows:
Take the accessories from the

appliance.
Insert the appropriate accessory into

the front of the appliance.
You may refit the other accessory by
clicking it into the accessory holder.
To refit both accessories:
Slide the crevice tool into the brush.

Push the accessories down until they

click into place.
Use
The appliance can be charged while

placed on a worktop or hung on the
wall using the wall hook provided.
The wall hook is not provided with
V1999 and V1999N.
Before first use, the battery must be

charged for at least 16 hours.
Leave the appliance connected to the

charger whenever it is not in use.
Charging the battery (fig. A)
Make sure that the appliance is

switched off. The battery will not be
charged with the on/off switch in the
on position.
Insert the charger plug (8) into the

charger connector (9) at the rear of
the appliance.
Plug in the charger (7).

Switch on at the mains.

Leave the appliance to charge for at

least 16 hours.
Whilst charging, the charger may
become warm. This is normal and does
not indicate a problem. The appliance
can be left connected to the charger
indefinitely.
Warning! Do not charge the battery at
ambient temperatures below 10 °C or
above 40 °C.
Switching on and off (fig. D)
To switch on, slide the on/off switch

(1) forward.
To switch off, slide the on/off switch

back.

Cleaning and maintenance

Warning! Regularly clean the filters.
Cleaning the dust bowl and filters
(fig. E & F)
The filters are re-usable and should be
cleaned regularly.
Press the release button (2) and

remove the dust bowl (3).
Empty the dust bowl.

Remove the filter assembly (10) by

twisting it clockwise.
Wash the filters in warm, soapy

water. The bowl can also be washed
if necessary. Do not immerse the
appliance in water.
Make sure the dust bowl and filters

are dry.
Refit the filter assembly (10) onto the

appliance, twisting it
counterclockwise until it locks into
place.
Refit the dust bowl onto the

appliance. Make sure the dust bowl
clicks into place.
Warning! Never use the appliance
without the filters. Optimum dust
collection will only be achieved with clean
filters and an empty dust bowl.
5