Microprocessor Control; Wireless Remote Controller; Indoor Unit Display Section - Mitsubishi Electric MSZ-G09SV Service Manual

9

MICROPROCESSOR CONTROL

MSZ-G12SV -
MSZ-G09SV -
E1
MSZ-G12SV -
MSZ-G09SV -
E2
9-1. on page 35 ~ 9-13. on page 47

WIRELESS REMOTE CONTROLLER

MSZ-G09SV -
E1
MSZ-G12SV -
E1
Signal transmitting section
Operation display section
OPERATE /STOP
(ON /OFF)button
ON/OFF
OPERATION SELECT button
FAN SPEED CONTROL button
ECONO COOL button
ON-TIMER button
CLOCK SET button
HR. button
MIN. button
(TIME SET button)

INDOOR UNIT DISPLAY SECTION

Operation Indicator lamp
The operation indicator at the right side of the indoor unit
indicates the operation state.
•The following indication applies regardless of shape of the indicator.
Operation Indicator
Indication Operation state
This shows that the
air conditioner is
operating to reach
the target temperature.
Please wait until the
target temperature is
obtained.
This shows that the
room temperature is
approaching the
target temperature.
MUZ-G09SV -
E1
MUZ-G09SV -
E2
AM CLOCK PM
6 00 1 1 00
TOO TOO
WARM COOL
TEMPERATURE buttons
MODE I FEEL COOL DRY HEAT
VANE
FAN
VANE CONTROL button
ECONO COOL
SWING
SWING button
STOP
START
OFF-TIMER button
HR. MIN.
CLOCK
RESET button
RESET
lighted
not lighted
Difference
between target
temperature
and room
temperature
Approx. 2 :
or more
Approx. 2 :
or less
MUZ-G12SV -
E1
MUZ-G12SV -
E2
MSZ-G09SV -
E2
MSZ-G12SV -
E2
Signal transmitting section
Operation display section
OPERATE /STOP
(ON /OFF)button
VANE control button
OPERATION SELECT button
ECONO COOL button
Vertical vane
swing button
RESET button
Once the operation mode are set, the same operation mode can
be repeated by simply turning the OPERATE/STOP(ON/OFF)
button ON.
Indoor unit receives the signal with a beep tone.
When the system turns off, 3-minute time delay will operate to
protect system from overload and compressor will not restart for
3 minutes.
9-1. "I FEEL CONTROL" (
1. Press OPERATE/STOP(ON/OFF) button on the remote
controller. OPERATION INDICATOR lamp of the indoor
unit will turn on with a beep tone.
2. Select "I FEEL CONTROL"(
TION SELECT button.
3. The operation mode is determined by the room tempera-
ture at start-up of the operation.
Initial room temperature
25: or more
23: to 25:
less than 23:
35
E1
E2
:
CLOCK
AMPM
AMPM
TOO TOO
ON/OFF
WARM COOL
TEMPERATURE buttons
CLOCK
PM
AMPM
TOO TOO
ON/OFF
WARM COOL
FAN SPEED CONTROL button
FAN STOP
I FEEL COOL OFF-TIMER button
VANE START
HEAT DRY
ON-TIMER button
MODE SWING HR.
HR. button
MIN. button
ECONO COOL MIN.
(TIME SET button)
RESET CLOCK
CLOCK SET button
) OPERATION
) mode with the OPERA-
Mode
COOL mode of
"I FEEL CONTROL"
DRY mode of
"I FEEL CONTROL"
HEAT mode of
"I FEEL CONTROL"