Checking The Setup Procedures; Peer-To-Peer Printing - Konica Minolta Network Interface Card NC-6 User Manual

Getting Ready
2.2

Checking the Setup Procedures

This section describes the required procedures for setting up network
printing for the selected network print method.

Peer-to-Peer Printing

1
Check that all of the accessories have been included in the package.
("3 Checking the Accessories")
2
Connect the network cable. ("4 Connecting the Network Cable")
3
Specify the IP address, subnet mask, and default gateway settings for
the copier. ("5 Assigning an IP Address")
4
Print the Configuration Page and check the settings. ("6 Printing the
Configuration Page")
Note
The Configuration Page cannot be printed for copiers that are not
equipped with the optional PCL printer controller or fax option.
5
Install the printer driver. The Peer-to-Peer Utility is installed when you
install the printer driver.
❍ For instructions on installing the GDI driver, refer to "GDI Printer
Controller" in the manual provided with the copier. For instructions
on installing the optional PCL driver, refer to "PCL Printer
Controller" in the manual provided with the PCL printer controller.
6
Add a network port to the computer. ("7 Connecting the Computer and
Copier")
NC-6
2
2-7