Disposal - Hilti DX 76 Operating Instructions Manual

en
The fastener guide
cannot be screwed on to
the tool fully.
The piston cannot be
fitted.
The piston guide cannot
be fitted.
Stiff cycling action.
If these measures fail to remedy the problem, please contact Hilti.

10. Disposal

Most of the materials from which Hilti powder-actuated tools are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements
for taking back your old powder-actuated tools for recycling. Please ask your Hilti customer service department
or Hilti sales representative for further information. Should you wish to return the tool yourself to a disposal facility
for recycling, proceed as follows: Dismantle the tool as far as possible without the need for special tools. National
and international directives and regulations must be observed.
Separate the individual parts as follows:
Part/assembly
Toolbox
Outer casing
Piston
Piston stopper
Screws, small parts
Used/partly-used cartridge strips
30
The fastener guide needs to be
cleaned.
Fasteners are jammed in the fastener
guide.
The piston stopper has been inserted
the wrong way round.
The piston guide needs to be cleaned
at the end of the threaded section.
The tool, the piston guide in particular,
needs to be cleaned.
The slider projects into the piston
guide and prevents movement of the
piston.
The lever is in the closed position.
The piston guide is incorrectly
positioned.
The tool needs to be cleaned.
Main material
Plastic
Plastic/synthetic rubber
Steel
Steel/plastic
Steel
Steel/plastic
Use the brushes provided to clean the
fastener guide and associated parts.
lubricate with Hilti spray.
Remove the jammed fasteners.
Avoid shear breakage (see above).
Avoid missing the beam (driving the
fastener into unsupported sheet metal);
mark the position of the beams
accurately if necessary.
Unscrew and remove the fastener guide.
Fit the piston stopper the right way
round.
Clean and lubricate the thread.
Clean the fastener guide and the tool and
refit the piston.
Pull the slider forward until it can
engage.
Open the lever.
Position the piston guide correctly when
inserting it.
Clean the piston guide.
Check the piston for straightness.
Clean the tool. –
Recycling
Plastics recycling
Plastics recycling
Scrap metal
Scrap metal
Scrap metal
In accordance with local regulations