Yamaha VK10W Supplementary Service Manual page 79

CABLE ROUTING
1 Positive battery lead
2 Negative battery lead
3 Pass the wire harness (two
leads) through the hole in the
cover.
4 Wire harness
5 A.C. magneto lead
6 Negative battery lead coupler
7 Positive starter motor lead
8 Fasten the A.C. magneto lead
and wire harness with the plastic
band.
9 Negative battery lead terminal
0 Positive battery lead terminal
A Oil level switch lead coupler
B Oil level gauge/dipstick
C Route the oil level switch lead
behind the battery bracket.
D Carburetor heater coupler
E Fasten the positive starter motor
lead and oil tank inlet hose with
the plastic band. Face the end of
the plastic band towards the bat-
tery bracket.
F Pass the carburetor heater lead
over the oil cooler outlet hose.
G Fasten the wire harness and
coolant hose with the plastic
band, making sure that the wire
harness is not routed under the
hose.
H Starter motor
I Coolant temperature sensor cou-
pler
J 45 ± 5 mm (1.77 ± 0.20 in)
K To the brake caliper
L Pass the coolant temperature
sensor lead over the coolant
hose.
M Less than 145 mm (5.71 in)
N Fasten the ignition coil lead and
wire harness to the frame cross
member with the plastic band,
making sure to face the end of
the band rearward.
O Place the main switch lead cou-
pler underneath the fuel tank
cover.
P Main switch
Q Handlebar switch lead couplers
R Tail/brake light sub-wire harness
coupler
S Throttle cable
T To the tail/brake light
U Thumb warmer switch lead cou-
plers
V Grip warmer connectors
W Headlight beam switch coupler
X Grip warmer adjustment switch
lead coupler
Y Brake light switch coupler
CABLE ROUTING
73
SPEC