Threading The Machine - Janome 204D Instruction Manual

Janome 204D Instruction Manual
3
4
6
A
3
www.aaasewing.com
14
5
2
1
4 3 2 1
7
1
2

Threading the Machine

The machine is pre-threaded to make threading
easier.
Tie the end of a new thread to one of the pre-set
threads, and pull it to draw the new thread through
the machine, following the steps below.
[1] Turn off the power switch before threading the
machine.
[2] Pull the threads from the spools and draw them
through the thread guides, then tie the thread
ends together.
[3] Raise the presser foot, draw the threads until the
knots are coming out from under the back of the
presser foot.
[4] However, stop drawing the needle threads when
the knots reach just before the needle eye.
Cut the knots and thread the needle eye.
[5] Before starting sewing, clear the needle threads
from under the presser foot to make sure they
are not caught below the needle plate.
Then pull out the threads to the back approxi-
mately 10 cm (4") away from the presser foot.
Lower the presser foot, and you are now ready to
sew.
For re-threading the machine easily, start from
the lower looper, upper looper, right needle and
left needle threads.
Make sure to clear the needle threads out from
below the needle plate and draw them to the
back and under the presser foot about 10 cm
(4").
1
Lower looper thread
2
Upper looper thread
3
Right needle thread
4
Left needle thread
5
Thread guide
6
Thread guide plate
7
Thread chart
If one of the threads is broken, follow the
re-threading procedure as follows:
[1] Raise the presser foot and pull the thread chain
out to the back of the presser foot, and cut the
chain to separate each of the threads.
[2] Rethread the thread which had been broken.
[3] Turn the handwheel toward you until the needle
comes to its highest position.
[4] Pull the threads from under the presser foot with
tweezers and pull out the needle threads above
the needle plate. Draw out 10 cm (4") away from
the presser foot. (Draw the needle thread in the
direction of A)
1
Needle
2
Needle thread
3
Needle plate
204D Owners Manual/ User Guide
Janome 204D serger