Xx-Motor (Hcit Elevator) Error Service Check; Go Back; 250.03-Paper Jam Error Service Check - Lexmark C746n Service Manual

5026
168.xx—Motor (HCIT elevator) error service check
Step Questions / actions
Is the paper properly loaded in the high-
1
capacity input tray (HCIT)?
1. Turn the printer off.
2
2. Reseat option the HCIT option.
3. Bring the printer up in Diagnostics Menu
(turn off the printer, press and hold
buttons 3 and 6, then turn on the printer).
4. Navigate to PRINT TESTS > HCIT >
Single.
Did the error clear?
1. Turn the printer off.
3
2. Remove the rear frame cover. See
frame cover removal" on page
3. Check the option cable in connector
JOPT1 on the system board for proper
connection, for cable pinch points, and for
any other damage to the cable or
connector.
Is the cable damaged?
1. Remove the HCIT right cover.
4
right cover removal" on page
2. Check the cable in the HCIT.
Is the cable damaged?
200.11, 250.03—Paper Jam error service check
Step Questions / actions
Open the front access door. Turn the
1
transport belt gear clockwise.
Did the transport belt move?
Service Manual
2-64
Yes
Go to step 2.
Problem resolved.
Replace the option cable.
See
"Option cable
"Rear
removal" on page
4-47.
See"HCIT Replace the elevator-up
cable.
4-196.
Yes
Go to step 2.
No
Fan the media, and then
stack flat in the HCIT
drawer.
Go to step 3.
Go to step 4.
4-135.
Replace the elevator motor
with sensor. See
elevator motor with
sensor removal" on
page 4-200.
No
Replace the transport belt.
See
"Transfer module
removal" on page
Previous
Next

Go Back

"HCIT
4-171.