Batteries; Lens; Flash Range; S-Mode - Minolta Maxxum 9 Instruction Manual

TROUBLE SHOOTING
PROBLEM
Batteries are loaded incorrectly.
No display appears
when the camera is
switched on. Batteries are exhausted.
Situation is unsuitable for autofocus.
Autofocus does not work
when shutter-release
Camera is set to manual focus mode.
button is pressed
partway down.
Subject is too close.
Focus cannot be confirmed.
Shutter cannot be
Camera is attached to a microscope or telescope.
released.
Custom Function 5 set to setting 2.
Flash picture is too dark. Subject is beyond flash range.
Lower part of flash
Lens hood attached.
picture is dark.
Err appears in the data
Camera Malfunction
panel.
108
CAUSE SOLUTION
Remove and reinstall the batteries.
If the camera battery is exhausted, install a new battery.
Use focus hold or manual focus.
Slide the focus-mode switch to AF.
Check the minimum focus distance for your lens.
Use focus hold or manual focus.
Set Custom Function 16 to setting 2.
Set Custom Function 5 to setting 1.
Make sure the subject is within the flash range.
Remove lens hood.
The distance between the subject and the camera must be at least
1m (3.3ft.) when the built-in flash is used.
Remove and reinstall the batteries. If normal camera operation does
not resume or the camera malfunctions repeatedly, contact an
authorized Minolta Service Facility.
• Contact your nearest Minolta Service Facility if the problem you are experiencing is not
covered or the condition continues.
PAGE
10
10
21/33
18
-
21/33
99
94
23
-
10
109