Miele heat pump dryer Operating Instructions Manual page 51

Heat pump dryers
Hide thumbs Also See for heat pump dryer:
Table of Contents

Advertisement

Problem
Clean out airways See
lights up after a pro‐
gramme is cancelled
Empty container see
lights up after a pro‐
gramme is cancelled
Fill condensate container
Open & close door
Comfort cooling
Cause and remedy
An excessive amount of fluff has built up.
 Clean the fluff filters.
 Clean the plinth filter.
Clean the airways:
 clean the area underneath the plinth filter
 clean the heat exchanger.
To switch off the message:
 Switch the dryer off and back on again.
The condensed water container is full or there is kink
in the drain hose.
 Empty the container.
 Check the drain hose.
To switch off the message:
 Open and close the door while the dryer is switch‐
ed on or switch the dryer off and back on again.
This is to remind you that water is taken from the
condensed water container when the Steam smooth‐
ing programme is being used.
The condensed water container must be filled with
water to at least the –min– marker.
 Confirm with OK.
This is to remind you to load the laundry when the
Steam smoothing programme is selected.
 Load the laundry in the drum.
The programme has finished but the laundry has not
yet cooled down.
 Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
Problem solving guide
51

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tmb640Tmg 440 wp

Table of Contents