Capresso CoffeeTEAM Pro Glass 477 Operating Instructions Manual page 8

• Rinse out the water tank for first time use and fill the water tank to the
12 cups marking. Place back onto the machine and press down to fully
engage the base valve.
• Remove the charcoal cartridge and measuring scoop from the carafe and
wash the carafe as described in chapter 10.1.
NOTE: The filter insert, GoldTone filter, the glass carafe and carafe lid are
dishwasher safe (upper rack, away from any heating element).
CAUTION: Do not immerse the machine in water or any other liquid.
• Let some water brew through the machine without any coffee as follows:
• Plug in machine and make sure the GoldTone filter and filter insert are in place.
• Place dry carafe with lid in the machine.
CAUTION: Never put wet carafe onto the heating plate! Always dry the
carafe before inserting back into the machine.
IMPORTANT: When brewing, always have the carafe lid and bean container
lid securely in place.
• Push the GROUND COFFEE button, then the BREW button (Fig. 2). The
machine starts processing the water into the carafe.
• After all water has passed through, push the BREW button again to turn off
machine.
• Empty carafe and dry.
7. PREPARING THE COFFEETEAM PRO
7.1 CLOCK AND GRINDER SETTINGS
Plug in machine. The display shows "12:00" blinking.
NOTE: You must set the actual time before you can operate the coffee maker.
a) Setting the Actual Time
• Push and hold the HOUR button until the actual hour is displayed. The display
will also show AM or PM.
• Push and hold the MINUTE button until the minutes are displayed. The time
is now set.
NOTE: You must change the clock when the time changes (Standard Time /
Daylight Savings Time).
b) Setting the Auto-On Time
You can only set the Auto-On Time after the actual time is set.
• Push and hold the AUTO button for 2-3 seconds until the display illuminates
with the clock icon and the clock icon starts blinking.
• Push and hold the HOUR, then the MINUTES button to set Auto-On time.
• If you will be using the grinder, select the number of cups you would like to
brew automatically by pressing the CUPS button. You may also choose to
program the machine to automatically brew with ground coffee. Push the
GROUND COFFEE button. Once pressed the CUPS number will disappear
and the ground coffee scoop icon will illuminate.
NOTE: You must program the CUPS button in Auto-On setting when using
the grinder to obtain the correct ground coffee volume to correspond to the
number of cups you will be brewing. See Grind Volume Setting below.
• Once desired Auto-On time is programmed, press the AUTO button again.
The display reverts to the actual time and the clock icon will remain illuminated.
• To turn off the Auto-On feature press the AUTO button again until the clock
icon disappears.
8