Table of Contents
Advertisement
AKG Technology, Inc. (http://www.akgtech.com)
Tele:(909)967-5572; Fax: (909) 580-8228; Email: engineer@akgtech.com
Mailing Address: 1225 Benito Avenue, #M, Alhambra, CA 91803, U. S. A.
2. Connect one end of the video cable to the rear side of computer and the other to the LCD
monitor. Tighten by turning the two thumb screws clockwise to ensure proper grounding.
3. Connect one end of the power adapter to the monitor and the other end to the connector of
the power cord.
4. Press the power button on the rear panel to turn the monitor power on.
NOTE：The touch monitor should be integrated according to the above process, if not
may result in the touch monitor working abnormally。
2.6 Installing the Driver Software and Calibration
2.6.1 Drivers can be downloaded from KeeTouch Driver CD (developed by
Touch base):
•
Windows 2000 (for both home version & professional version)
•
Windows XP (for both home version & professional version)
•
Windows Vista (for both home version & professional version)
2.6.2 Drivers Supply from Technical Support email (developed by KeeTouch):
•
Windows XP embedded
•
Linux
Your KeeTouch touch monitor is Plug-and-Play compliant. Information on the video capabilities of your
touch monitor is sent to your video display adapter when Windows starts. If Windows detects your
touch monitor, follow the instructions on the screen to install a generic Plug-and-Play monitor.
2.6.3 Installing the Driver Software
Driver installation and Touch System calibration guide:
(1) Preparation: connecting SAW touch screen, controller and application device or computer with
correct cable on the integration procedure.
(2) Insert the KeeTouch Driver CD in to application system;
(3) Follow the instruction to complete the driver installation
5 - 11
LCD Open frame SAW Touch Monitor
Advertisement
Table of Contents
