Attaching The L-Bracket; Interface Connection - AKG KOT-0190US-SA4B User Manual

AKG Technology, Inc. (http://www.akgtech.com)
Tele:(909)967-5572; Fax: (909) 580-8228; Email: engineer@akgtech.com
Mailing Address: 1225 Benito Avenue, #M, Alhambra, CA 91803, U. S. A.
spaced at 75mm and 100mm standard.
NOTE: Do not penetrate the M4 screw into the monitor more than 5mm.
2.4 Attaching the L-Brackets
To attach the L-brackets:
1 Lay the monitor face down.
2 Place the long end of the L-bracket against the side of touch monitor. Line up the two
holes of the L-bracket with the two holes of the touch monitor.
3 Place two M4 screws in the holes and with the screwdriver; screw them in to secure the
bracket.
4 Repeat steps 2 and 3 to attach the other L-bracket to the other side of the touch monitor.
NOTE: The way to attach the L-brackets has two options, See the illustration below:
Option 1 Option 2
L-brackets to the left and right sides L-brackets to the up and down sides

2.5 Interface Connection

Note: Before connecting the cables to your touch monitor and PC, be sure that the
computer and touch monitor are turned off.
1. Connect one end of either the serial (RS232) cable or the USB cable (but not both) to the
rear side of the computer and the other end to the LCD monitor. Tighten by turning the two
thumb screws clockwise to ensure proper grounding (USB cable does not have thumb
screws).
4 - 11 LCD Open frame SAW Touch Monitor