Answering And Making Calls Answering Calls; Ending Calls; Making Calls; Making Three-Way Calls On An Analogue Line - Konftel 300 User Manual

ansWerinG anD MaKinG calls
ansWerinG calls
A ring tone is heard and the blue LEDs start flashing.
 Press to answer.
The LEDs show a steady blue light. The duration of the call is shown on the display screen.

enDinG calls


End the call by pressing .

MaKinG calls


Dial the number.

Press .
The number is called and the LEDs show a steady blue light. The duration of the call is shown
on the display screen.
Or:

Press .
 Dial the number.
The number is called and the LEDs show a steady blue light. The duration of the call is shown
on the display screen.
redialling
 Press an arrow button.
The last number that you dialled appears on the display screen.
 Use the arrow buttons to look through previously dialled numbers.

Press .
The number you select is dialled.
calling from the phonebook
Please turn to page 17 for instructions on adding and updating contacts in the phone-
book.

Press and hold down a number button for two seconds.
The phonebook appears on the display screen. The pre-programmed names appear in alphabeti-
cal order, starting with the number button's first letter.
 Use the arrow buttons to look through the phonebook.
 Press .
The contact you select is dialled.
8
ansWerinG anD MaKinG calls

MaKinG THree-WaY calls on an analoGUe line

The simplest way to set up a multi-party call is to use the conference guide (see page
13). You can connect another party to an on-going call as follows. During a call, the
button acts as R-pulse (flash), which means it transmits commands to the PBX.
Please note that you may need to adjust some settings in your Konftel 300 to make it
compatible with your PBX. Please turn to page 15 in this User Guide for more details.
 Press .
A second dialling tone is heard.

Dial the second participant's number and wait for an answer.

Press the (r) button and then 3.
All three participants are now linked together in one call.
if you don't get an answer when you dial the second number
 Go back to the first call by pressing
VoiP calls
For these instructions, it is assumed that the computer is turned on, the VoIP software
(e.g. Skype ) is running and the Konftel 300 is connected to the computer via the USB
®
cable.
line mode
 Press line MoDe and select USB as a phone line using the arrow buttons. Press
oK to confirm.
connecting two lines
MOBILE+USB connects calls via mobile telephones with VoIP calls over the Internet.
ANALOGUE+USB connects calls on analogue lines with VoIP calls over the Internet.
Making VoiP calls
 Press .
The Konftel 300 has now been put into call mode and the LEDs show a steady blue light.
 Indicate whether you want to connect a call with one user or several users in the
computer's VoIP software.
The Konftel 300 functions as a speaker and microphone for the computer.
(r) then 1.
9