Table of Contents
Advertisement
Chipset Configuration:
Chipset Configuration
AGP Aperture Size
Onboard VGA Share Memory
USB Controller
USB Device Legacy Support
USB 2.0 Controller
DRAM CAS# Latency
MA 1T/2T Select
Vccm Voltage
Defer Function
CPU Thermal Throttling
No-Excute Memory Protection
AGP / PCI Fix Frequency
F1:Help
Esc:Previous Menu
AGP Aperture Size: It refers to a section of the PCI memory address range
used for graphics memory. It is recommended to leave this field at the
default value unless your AGP card requires other sizes.
OnBoard VGA Share Memory: This allows you to select the size of share
memory for onboard VGA. Onboard VGA will get better resolution if larger
size of share memory is selected.
USB Controller: Use this to enable or disable the use of USB controller.
USB Device Legacy Support: Use this to enable or disable support to emulate
legacy I/O devices such as mouse, keyboard,... etc.
USB 2.0 Controller: Use this to enable or disable the use of USB 2.0 controller.
DRAM CAS# Latency: This parameter controls the latency between the read
command and the time the data available.
MA 1T/2T Select: Use this item to meet the timing and loading condition for
optimized result of DRAM address/control signals. The default value of this
item is [MA2T], and other configuration options are [Auto] and [MA1T].
Vccm Voltage:
Defer Function: It allows you to adjust defer function.
[Auto].
CPU Thermal Throttling: Select [Enabled] will enable P4 thermal control cir
cuit to keep CPU from overheated.
2 4
AMIBIOS SETUP UTILITY - VERSION 3.31a
Advanced
:Select Item
Use this to select VCCM voltage between [2.62V] and [2.55V].
64MB
Auto
Enabled
Disabled
Enabled
Auto
MA2T
2.62V
Auto
Enabled
Enabled
Sync.
+/-:Change Values
Enter:Select
Sub-Menu
[ Setup Help ]
<Enter> to select the
size of mapped memory
for graphics data.
F9:Setup Defaults
F10:Save & Exit
The default setting is
Advertisement
Table of Contents
