Table of Contents
Advertisement
2.8 Onboard Headers and Connectors
Connectors are NOT jumpers. DO NOT place jumper caps over
these connectors.
FDD Connector
(33-pin FLOPPY1)
(see p.7, No. 19)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE Connector (Blue)
(39-pin IDE1, see p.7, No. 9)
PIN1
connect the blue end
to the motherboard
Note: If you use only one IDE device on this motherboard, please set the IDE
device as "Master". Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
USB 2.0 Header
(9-pin USB45)
(see p.7, No. 16)
Infrared Module Header
(5-pin IR1)
(see p.7, No. 14)
Internal Audio Connectors
(4-pin CD1, 4-pin AUX1)
(CD1: see p.7, No. 23)
(AUX1: see p.7, No. 24)
1 6
FLOPPY1
Pin1
IDE1
80-conductor ATA 66/100/133 cable
USB_PWR
P-5
P+5
1
P+4
P-4
USB_PWR
IRTX
+5V
1
GND
IRRX
AUX-R
GND
GND
AUX-L
AUX1
Secondary IDE Connector (Black)
(39-pin IDE2, see p.7, No. 8)
IDE2
PIN1
connect the black end
to the IDE devices
ASRock I/O Plus
6 ready-to-use USB 2.0 ports on
GND
DUMMY
the rear panel. If the rear USB
ports are not sufficient, this
GND
USB 2.0 header is available to
support 2 extra USB 2.0 ports.
This header supports an optional
DUMMY
wireless transmitting and
receiving infrared module.
These connectors allow you
CD-R
GND
to receive stereo audio input
GND
CD-L
from sound sources such as
CD1
a CD-ROM, DVD-ROM, TV
tuner card, or MPEG card.
the red-striped side to Pin1
TM
provides you
Advertisement
Table of Contents
