Multiple Intake Ports; Check The Sytem; Bag/Bagless Option; System Check Led - Hoover Windtunnel Owner's Manual

Multiple intake ports

3.4 The Power Canister is equipped with two (2)
Intake Ports on the back. Once installation of the
Central Vac System is complete, the intake port that
was not used must be capped with the Vac Cap
Assembly. This assembly is packed in the dust
container of your Power Canister.
CheCk the systeM
Check each connection for proper seal and that no
air leaks occur.
If one is present, you may hear a "hissing" sound.
Correct if present. Check each inlet valve for air
leaks.
Start the system by plugging the hose into each
valve to make sure it functions properly.
Your Central Vacuum Cleaning System is now
ready for your use.

BaG/BaGless option

To use CV with a bag, insert flat end of the filter bag
adaptor to the inlet port. Insert the bag opening over
the ribbed end of the filter bag adaptor, ensuring the
bag is secure.
NOTE: Do not clean out old bag and reuse. Discard
used filter bag

systeM CheCk led

When the time incremented gets to 20 hours, the
LED will start a slow blinking sequence. The LED is
to blink whether the motor is running or not after the
timer is reached.
Slow Blink sequence is about 0.5s on and 0.5s off.
When the reset button - located on the left side of
the machine - is held more than 3 seconds, this will
reset the 20 hour timer. This reset will occur at any
moment in time before 20 hours, at 20 hours and
after 20 hours when the reset button is held for
more than 3 seconds. The reset will be acknowl-
edged by the LED fast blinking 3 times (blinking
rate is about 0.25s on and 0.25s off).
3.4
bag Installed
8
bag noT Installed