Installing A Dvd-Rom Or Floppy Drive; Replacing The Internal Transcoder Device - Bosch DIVAR IP 6000 1U Installation Manual

DIVAR IP 6000 1U
Notice!
We recommend using the respective Bosch hard disk drives. The hard disk drives as one of
the critical component are carefully selected by Bosch based on available failure rates. HDD –
not delivered from Bosch – are not supported. Information on supported HDDs can be found
in the datasheet in the Bosch Online Product Catalog.
3.3

Installing a DVD-ROM or floppy drive

The Bosch models come without a DVD-ROM. Due to the Bosch specific setup a DVD-ROM
drive is not needed for operations and / or maintenance.
To install or replace a DVD-ROM or floppy drive:
1.
2.
3.
4.
5.
6.
7.
3.4

Replacing the internal transcoder device

The chassis model includes an internal USB transcoder device.
Notice!
To replace or install the transcoder device, please apply to one of the Bosch RMA helpdesks.
Bosch Sicherheitssysteme GmbH
Turn off the system and if necessary, remove the unit from the rack and the front bezel
from the chassis.
Remove the chassis cover.
Unplug the drives power and data cables from the motherboard and/or backplane.
If you are adding a new drive:
Remove the mini-bezel (grate) from the drive bay. The bezel can be removed by pulling
out the hard drive beneath the DVD-ROM or floppy drive bay, then pulling the mini-bezel
forward.
If you are replacing a drive:
Locate the locking tab at the rear (left hand side when viewed from the front) of the DVD-
ROM or floppy drive. Push the tab toward the drive and push the drive unit out the front
of the chassis.
Insert the new drive unit in the slot until the tab locks in place.
Reconnect the data and power cables.
Replace the chassis cover. replace the unit in the rack, if necessary, then turn on the
system.
Installation manual
Chassis setup and maintenance | en
2014.01 | V2 | DOC
17