Oki MICROLINE 385/6 Handbook page 84

Reassign graphics codes Decimal
Hexa-
decimal
ASCII
Reassign graphics codes
27 63 n m
1B3F n m ESC ? n m
n = "K" "L" "Y" or "Z" m = 0, 1, 2, 3, 4, 6, 32, 33, 38, 39, 40
Epson
You can reassign any of the eleven 8- and 24-pin high resolution graphics rr
the low resolution graphics command (ESC K, ESC L, ESC Y or ESC Z).
For n, substitute one of the four letters (K, L, Y or Z, decimal 75, 76, 89 or 9(
which of the four commands you are redefining. The variable m stands for de
the modethatyou are reassigning to the redefined code. (Seethe Epson colurr
Resolution Graphics Density Codes table.) Then, when you are ready to prir
pattern, send the redefined low resolution command, followed by the graphi
Example
The following BASIC statement reassigns 24-pin hex density to the commai
LPRINT CHR$(27)"?L",CHR$(40)
Select Aspect Ratio Decimal
Hexa-
decimal
ASCII
Select Aspect Ratio 27 110 d 1В 6E d ESC n d
This command specifies the horizontal to vertical aspect ratio for the graphi
commands, ESC K, ESC L, ESC Y and ESC Z.
d = 0 or 1: select aspect ratio of 5:6
d = 2: select aspect ratio of 1:1
d > = 3: ignored
The aspect ratio determines the vertical dot density depending on the bit imac
being used.
5-10