Adjusting The Head Position; Left - Right Pressure Balance Setting - SATO s84ex Operator's Manual

5 Cleaning and Performing Printer Adjustments

5.7 Adjusting the Head Position

5.7.1

Left - Right Pressure Balance Setting

Required tool:
Phillips screwdriver
The adjustment procedure for the pressure balance is as follows:
1
Open the top cover of the printer.
2
Make sure that the head lock lever is in the lock position.
If it is not locked, turn the head lock lever counterclockwise to lock the print head.
3
Locate the adjust collar  on the side of
the print head assembly.
4
Loosen the screw  attached to the adjust
collar .
Do not remove the screw.
5
Rotate the adjust collar  to adjust the
head pressure balance.
• Rotate the adjust collar counterclockwise to
increase the head pressure on the frame side.
• Rotate the adjust collar clockwise to increase the
head pressure on the opposite side.
Note
If the printer orientation is opposite from the photo, the
adjustment direction is reversed.
6
Hold the adjust collar  in the set position
and tighten the screw .
218
S84-ex/S86-ex Operator Manual
1
2
1