Flange Back Check; Picture Frame Setting; Light Switch (Fk-2000 Block); Digital Zoom (Menu Display) - Sony Handycam Vision CCD-TRV107E Service Manual

4. Flange Back Check

Subject Siemens star
(2.0m from the front of the lens)
(Luminance : approx. 200 lux)
Measurement Point Check operation on TV monitor
Measuring Instrument
Specified Value Focused at the TELE end and WIDE
end.
Note: When the auto focus is ON, the lens can be checked if it is focused
or not by observing the data on the page 1 of the adjustment remote
commander.
1) Select page: 0, address: 03, and set data: 0F.
2) Page 1 shows the state of the focus.
1 : 00 : XX
Switch setting:
NIGHT SHOT (Lens block) ............................................ OFF
Checking method:
1) Select page: 6, address: 40, and set data: 02.
2) Select page: 6, address: 41, and set data: 01.
3) Place the Siemens star 2.0m from the front of the lens.
4) To open the IRIS, decrease the luminous intensity to the
Siemens star up to a point before noise appear on the image.
5) Shoot the Siemens star with the zoom TELE end.
6) Turn on the auto focus.
7) Check that the lens is focused (Note).
8) Select page: 6, address: 21, and set data: 10.
9) Shoot the Siemens star with the zoom WIDE end.
10) Observe the TV monitor and check that the lens is focused.
Processing after Completing Adjustments:
1) Select page: 6, address: 21, and set data: 00.
2) Select page: 6, address: 40, and set data: 00.
3) Select page: 6, address: 41, and set data: 00.
4) Select page: 0, address: 03, and set data: 00.
CCD-TRV107E/TRV108E/TRV208E/TRV408E
Odd: Focused
Even: Unfocused
5-15

5. Picture Frame Setting

Subject Color bar chart
(Color reproduction adjustment frame)
(1.5m from the front of the lens)
Measurement Point Video output terminal
Measuring Instrument Oscilloscope and TV monitor
Specified Value A=B, C=D, E=F
Note: The following adjustments should be carried out upon completion
of "Flange back adjustment".
Switch setting:
1) NIGHT SHOT (Lens block) ............................................ OFF
2) DIGITAL ZOOM (Menu display) ................................... OFF
3) STEADY SHOT (Menu display) ..................................... OFF
4) LIGHT (FK-2000 block) .................................................. OFF
Setting method:
1) Adjust the zoom and the camera direction, and set to the
specified position.
2) Mark the position of the picture frame on the monitor display,
and adjust the picture frame to this position in following
adjustments using "Color reproduction adjustment frame".
Check on the oscilloscope
1. Horizontal period
A=B
B
A
Fig. 5-1-8.
2. Vertical period
E
Fig. 5-1-9.
Check on the monitor TV (Underscanned mode)
Color bar chart picture frame
Fig. 5-1-10.
C=D
C
D
E=F
F
V
Monitor TV picture frame