LanParty Blood-Iron P45 Elite Series User Manual page 65

Suspend Mode
This is configurable only when the Power Management field is set to "User De-
fine". When the system enters the power saving time set in this field, the CPU
and onboard peripherals will be shut off.
HDD Power Down
This is configurable only when the Power Management field is set to User Define.
When the system enters the power saving time set in this field, the hard disk
drive will be powered down while all other devices remain active.
Soft-Off by PWR-BTTN
This field allows you to select the method of powering off your system.
Delay 4 Sec.
Regardless of whether the Power Management function is enabled or disabled,
if the power button is pushed and released in less than 4 sec, the system en-
ters the Suspend mode. The purpose of this function is to prevent the system
from powering off in case you accidentally "hit" or pushed the power button.
Push and release again in less than 4 sec to restore. Pushing the power but-
ton for more than 4 seconds will power off the system.
Instant-Off
Pressing and then releasing the power button at once will immediately power
off your system.
Wake-Up by PCI Card
Enabled
This field should be set to Enabled only if your PCI card such as LAN card or
modem card uses the PCI PME (Power Management Event) signal to remotely
wake up the system. Access to the LAN card or PCI card will cause the sys-
tem to wake up. Refer to the card's documentation for more information.
Disabled
The system will not wake up despite access to the PCI card.
USB KB Wake-Up From S3
This field, when enabled, allows you to use a USB keyboard to wake up a system
that is in the S3 (STR - Suspend To RAM) state. This can be configured only if
the "ACPI Suspend Type" field is set to "S3(STR)".
PowerOn By Alarm
Enabled
When Enabled, you can set the time you would like the Soft Power Down
(Soft-Off) PC to power-on in the "Time (dd:hh:mm) of Alarm" field. However,
if the system is being accessed by incoming calls or the network prior to the
time set in the field, the system will give priority to the incoming calls or
network.
Disabled
Disables the automatic power-on function. (default).
3
BIOS Setup
65