LanParty Blood-Iron P45 Elite Series User Manual page 42

2
Hardware Installation
PWR-LED: Power/Standby LED
When the system's power is on, this LED will light. When the system is in the
S1 (POS - Power On Suspend) or S3 (STR - Suspend To RAM) state, it will blink
every second.
Note:
If a system did not boot-up and the Power/Standby LED did not light af-
ter it was powered-on, it may indicate that the CPU or memory module
was not installed properly. Please make sure they are properly inserted
into their corresponding socket.
HD-LED
(Primary/Secondary IDE LED)
Reserved
ATX-SW
(ATX power switch)
Reserved
RESET
(Reset switch)
SPEAKER
(Speaker connector)
PWR-LED
(Power/Standby LED)
42
Pin Pin Assignment
3 HDD LED Power
5 HDD
14 N. C.
16 N. C.
8 PWRBT+
10 PWRBT-
18 N. C.
20 N. C.
7 Ground
9 H/W Reset
13 Speaker Data
15 N. C.
17 Ground
19 Speaker Power
2 LED Power (+)
4 LED Power (+)
6 LED Power (-) or Standby Signal