Setting Items
1st page
2nd page
13: Interface
1: Receive Buffer Capacity
Settings
2: BUSY Condition
3: Auto Line Feed
4: State to cancel buffer BUSY
5: Output Paper-end Signals
6: Error Signal
15: Logo Emulation
16: Automatic
1: Upper Margin
Paper
2: Lower Margin
Reduction
3: Blank Line Spacing
4: Blank Space
5: Barcode Height
17: Interface Selection
18: Power Supply Unit Capacity
Selection of software settings
The initial setting is underlined.
3rd page
4KB, 45 bytes
Receive Buffer Full or Offline, Receive
Buffer Full
Always disabled, Always enabled
Not BUSY = 256 bytes, Not BUSY = 138
bytes
Paper End Sensor Enabled, Disabled
Enabled, Disabled
Off, 180 Dpi Logo Mode
Enable, Disable
Enable, Disable
25%, 50%, 75%, Not Reduce
25%, 50%, 75%, Not Reduce
25%, 50%, 75%, Not Reduce
UIB, Built-in USB, Auto
Level 1(Low) to Level 3(High)
Appendix
95